84 at 397.8 eV, and the ratio of the azobenzene peak (N2) was 0.16 at 400.1 eV, for a 3,600-L aniline sample on the GOx NSC 683864 cost surface [19, 20]. These N 1 s peaks indicated that aniline had oxidized to azobenzene in the presence of the oxygen groups on the GOx surface, which suggested that the GOx surface acted as a reaction reagent at 300 K. The oxidation reaction efficiency under click here a 365-nm UV light exposure was measured as the aniline coverage was increased from 3,600 L to 14,400 L. Figure 3 HRPES measurements indicating oxidation from aniline to azobenzene on GOx surfaces prepared using benzoic acid. N 1 s core level spectra of (a) 3,600 L aniline on EG at 300 K, (b) 3,600
L aniline on a GOx surface prepared using benzoic acid at 300 K. The N1 and N2 peaks corresponded to the aniline and azobenzene nitrogen peaks. (c) and (d) show the plots of the intensity ratio between the N1 and N2 features as a function of the aniline coverage
on the EG and GOx surfaces, respectively. The plots of the coverage-dependent intensity of the aniline peaks (N1) and the azobenzene peaks (N2) on the EG and GOx surfaces are displayed in Figure 3c,d. Figure 3c shows that the intensity ratio remained unchanged, although the exposure of aniline was increased to 14,400 L. Thus, we concluded that GS-9973 ic50 the EG surface did not promote the oxidation reaction process because oxygen groups were not present. Figure 3d, on the other hand, clearly revealed that the relative intensity ratio between aniline and azobenzene increased with increasing aniline coverage on the GOx surface. As the aniline coverage increased from 3,600 L to 14,400 L aniline, the azobenzene (N2) peak increased significantly from 0.16 to 0.71 whereas the aniline (N1) peak
decreased from 0.84 to 0.29. These results suggested that the high concentration of aniline enhanced the occurrence of azobenzene due to the Le Chatelier’s principle on the GOx surface. It can be clearly explained that as the aniline coverage increased, the oxidation reaction involving the oxygen carriers on the GOx surface proceeded with greater efficiency because the high aniline coverage buy C59 increased the possibility of the oxidation reaction. Table 1 summarizes the aniline and azobenzene intensity measurements as a function of the aniline surface coverage. Table 1 Intensity measurements indicating relative aniline and azobenzene coverage Aniline exposure (L) Relative intensity of aniline (N1) Relative intensity of azobenzene (N2) 3,600 0.84 0.16 4,800 0.45 0.55 7,200 0.40 0.60 9,000 0.35 0.65 10,800 0.31 0.69 14,400 0.29 0.71 A function of aniline surface coverage at 300 K. The work function was measured as the center position of the low kinetic energy cut-off for each sample, as shown in Figure 4a. The monolayer EG spectrum (the black spectrum in Figure 4a) yielded a work function of 4.31 eV [20, 21].