For UV illumination, a UV lamp with the center wavelength at 365 

For UV illumination, a UV lamp with the center wavelength at 365 nm is turned on and off alternatively for every 100 s. Results and discussion Figure 2 show the SEM (scanning electron microscope) images of selectively grown ZnO nanowire array on the inkjet-printed Zn acetate buy RXDX-101 droplets. The ZnO nanowires grew only on the Zn acetate printed patterned. The initial printed droplet size of the Zn acetate precursor was 100 to 120 μm in diameter at room temperature. The usual length of the individual ZnO nanowire was around 1 to 3 μm with 100 to 150 nm in diameter after one time growth

and longer nanowire could be obtained by introducing the samples repeatedly into fresh solution baths every several hours. ZnO nanowires have hexagonal cross sections and grow along the c-axis of the wurtzite crystal in the [0001] direction. Bottom inset schematics show the cross-sectional view of the grown ZnO nanowire array. The ZnO nanowire arrays are grown vertically within ±10° deviation angle on the central part of a circular pattern while urchin-like nanowires are grown at the edge of the circular pattern. The urchin-like dense ZnO NWs show highly ordered outward radial directional growth because urchin-like radial growth minimizes the interaction among each nanowires and the affluent precursor supply from

outside of the circular seed pattern redirects the nanowire growth to the outward direction compared with the central AZD5363 clinical trial part [9]. Figure 2 SEM pictures of the hydrothermally grown ZnO nanowire array on the inkjet-printed Zn http://www.selleck.co.jp/products/Rapamycin.html acetate patterns. (a) ZnO nanowire array size variation at increased substrate heating; room temperature, 30°C, 40°C, 50°C, 60°C, and 70°C heating from left to right. Inset schematics show the cross sectional view of the ZnO nanowire array. (b) Magnified SEM pictures of 50°C, 60°C, and 70°C from left to right. Blue dotted lines indicate the elevated ZnO array at the center of the droplet due to substrate heating. The inkjet print head with 50-μm-diameter nozzle

originally generated 50-μm Zn acetate ink droplets, and they spread out and dried to various sized circular pattern depending on the substrate heating condition. Substrate heating can reduce the spreading of the Zn acetate ink. Figure 2a shows that the grown ZnO array size can be adjusted by substrate heating from room temperature to 70°C (room temperature, 30°C, 40°C, 50°C, 60°C, 70°C, respectively from left). The inkjet-printed precursor droplet will dry on the substrate. Substrate heating will buy AZD6244 accelerate the drying rate and subsequently increase contact line receding rate as the heating temperature increases. At high drying rate, the contact line will recede to smaller pattern to reduce to the size of the grown ZnO nanowire array. As the heating temperature increases, elevated ZnO nanowires were observed at the center of the droplet as indicated as blue dotted lines in Figure 1.

Comments are closed.