In our approach, we temporarily arrest the drying process

of a partially wet latex film by sealing it in an airtight chamber previously cooled to near the latex T-g. At these conditions, we are able to effectively stop the drying process and the polymer diffusion. FRET measurements at various locations on such a sample provide us information AZD9291 order about the mechanism operating at the initial stages of polymer diffusion as the latex film is still drying. We complete our study with FRET measurements carried out at longer aging times on predried latex films. We analyze our diffusion data in terms of free volume theory and propose a mechanism that can account for the results obtained. (C) 2011 Elsevier Ltd. All rights reserved.”
“Pb(Zr0.35Ti0.65)O-3 (PZT) films 170 nm thick were prepared at 415 degrees C by pulsed metal-organic chemical vapor deposition. The (111)-oriented PZT films with local epitaxial growth were obtained on (111)SrRuO3/(111)Pt/TiO2/SiO2/Si Selleck AC220 substrates and their ferroelectricities were ascertained. Ferroelectricity was improved by postannealing under O-2 gas flow up to 550 degrees C. Larger remanent polarization and better fatigue endurance were obtained using a SrRuO3 top electrode compared to a Pt top electrode for PZT films after annealing at 500 degrees

C. (C) 2009 The Japan Society of Applied Physics”
“The aim of the work was to produce inhalable capreomycin powders using a novel spray-drying technology. A 2(3) factorial design was used to individuate the best working conditions. The maximum desirability was identified at the smallest mean volume diameter (d(v)) and span, and the highest yield. Powders were characterized for size, morphology, flowability and aerodynamic properties. Mathematical models showed a good predictivity with biases lower than 20%. The maximum conformity with desirability criteria was obtained spraying a 10 mg/mL bacitracin solution at 111 degrees C with

the 4 mm pore size membrane. By processing capreomycin sulfate with the parameters optimized for bacitracin, an inhalable powder was obtained (i.e., yield of 82%, d(v) of 3.83 mu m, and span of 1.04). By further optimization, capreomycin sulfate powder characteristics were improved KU-57788 nmr (i.e., yield, similar to 71%; dv, 3.25 mm; span, 0.95). After formulation with lactose, emitted dose and respirable fraction of 87% and similar to 27% were obtained, respectively. Two capreomycin sulfate powders with suitable properties for inhalation were produced using the nano spray-dryer B-90. (C) 2014 Elsevier B. V. All rights reserved.”
“The role of cell-free extracellular matrix (ECM) in triggering tissue and organ regeneration has gained increased recognition, yet current approaches are predominantly based on the use of ECM from fully developed native tissues at nonhomologous sites.