% Ni-15 at % Si alloy supercapacitors with higher narrow cavity d

% Ni-15 at.% Si alloy supercapacitors with higher narrow cavity densities and higher

electric resistivities, with an aim to obtain further wide behaviors for Ti-Ni-Si ones, in comparison with those of the de-alloyed Si-Al alloy one [10, 11]. Experimental Materials The rotating wheel method under an He atmosphere was used for preparing Ti-15 at.% Ni-15 at.% Si alloy ribbons of 1 mm width and a thickness of about 50 μm, using a single-wheel melt-quenching apparatus (NEV-A05-R10S, Nisshin Gikken, Saitama, Japan) with rotating speed of 52.3 m/s. De-alloying GDC-0941 datasheet and anodic oxidation of the specimens were carried out for 288 ks in 1 N HCl solution and for 3.6 ks in 0.5 Mol H2SO4 solution at 50 V and 278 K, respectively. The densities of the specimen before and after surface treatment were 4.424 and 3.878 Mg/cm3, respectively. Characterization The phase transformations upon heating were studied by differential scanning calorimetry (DSC) at a heating rate of 0.31 K/s using 10-mg specimens. The check details structure of specimens was identified by X-ray diffraction with Cu Kα radiation in the grazing incidence mode. Topography images were observed using a noncontact atomic force microscope (NC-AFM, JSPM-5200, JEOL, Akishima, Tokyo, Japan). A scanning Kelvin probe force microscopy (SKPM) based on the measurement of electrostatic force gradient was applied to measure an absolute electrical

potential between the cantilever tip coated with Pt at 0 eV and TiO2 surface as the work function difference. Discharging measurement The specimen (1 mm wide, 50 μm thick, and 10 mm long) with double–oxidized surface was sandwiched directly by two copper ribbons beneath two pieces of glass plates using a clamp. Capacitances were calculated as a function of frequency

between 1 mHz and 1 MHz from AC electric charge/discharge pulse curves Decitabine in vitro of 10 V applied at 25 ns ~ 0.1 s intervals, using a mixed-signal oscilloscope (MSO 5104, Tektronix, Beaverton, OR, USA) and 30 MHz multifunction generator (WF1973, NF Co, Yokohama, Japan) on the basis of a simple exponential transient analysis. The charging/discharging behavior of the specimen was analyzed using galvanostatic charge/discharge on a potentiostat/galvanostat (SP-150, BioLogic Science Instruments, Claix, France) with DC’s of 10 V, 10 pA ~ 100 mA for ~900 s at room temperature. The details of the procedure have been described in previous paper [13]. Experimental inspection for electric storage was carried out by swing of reflected light of DC Galvanometer (G-3A, Yokogawa Electric, Tokyo, Japan) after charging at 1 mA for 20 s. Results and discussion Thermoanalysis and phase analysis of anodic oxidized alloys The DSC trace of the studied Ti-15 at% Ni-15 at% Si alloy ribbons shown in Figure 1a exhibits an increment in Cp at the glass this website transition temperature (Tg) of 555 K and one clear exothermal peak with peak temperature of 836 K.

Comments are closed.